Evercoat Rage Gold Nikki/ Bog/ Filler for Panel Beaters 3LT with Cream Hardener

Description

Evercoat Rage Gold Nikki/ Bog/ Filler for Panel Beaters 3LT with Cream Hardener

 

Evercoat Rage Gold Premium Body Filler is an exceptionally easy sanding body filler. Rage Gold contains ZNX-7® for adhesion to galvanized steel and aluminum. Blue cream hardener included. Evercoat’s easiest sanding body filler. The unsurpassed sanding qualities are attributed to Hattonite™, a unique ingredient which reduces heat and friction created by aggressive sanding. Plus, it’s stain resistant for use with basecoat/clearcoat paints.

Evercoat’s easiest sanding body filler. The unsurpassed sanding qualities are attributed to Hattonite, a unique ingredient which reduces heat and friction created by aggressive sanding.

 

 

Volume:	3 Litres
Approved Substrates:	Steel, Aluminum, Fiberglass, Galvanized Steel and SMC.

NOTE: For structural repairs prone to high degrees of stress and flexibility, use a
fiber reinforced filler such as Everglass®, Kitty Hair® or Fiber Tech®.

 

PREPARATION:

1. Clean and degrease the entire panel to be repaired with soap and water, followed by a mild cleaning solvent. Thoroughly dry the surface before repairing.
2. Keep the repair area small. Use 80 grit to remove the paint and featheredge.

 

MIXING:
1. Stir the filler before using. Knead the cream hardener.
2. Measure hardener 2% by weight (add a ribbon of cream hardener from edge to edge across the center of a 4” diameter puddle).
3. Puddles larger than 4” (10 cm) in diameter will require additional hardener.
4. Mix thoroughly until uniform color is achieved.
5. Approximate setting time is 3-5 minutes @ 72°F (22°C)

 

APPLICATION:

1. Apply in layers with even firm pressure.
2. Do not apply all at once.

 

FINISH:

1. Sand body filler with 80 grit sandpaper.
2. Finish sand body filler with 180 grit. Sand bare metal and featheredge with 180 grit to remove 80 grit scratches.