Description
Concept Paints MS 100 Primer Kit 5lt
This is a two pack primer surfacer that has been formulated to provide optimum sanding properties. It dries quickly developing excellent filling properties, with adhesion to most surfaces. It is suitable as a primer for all types of finishes.
– What You Will Recieve
• Concept MS 100 2K Primer Surfacer 4lt
• Concept Uni-Hardener (MS) Fast
– SUITABLE SUBSTRATES:
• Sound existing finishes.
• Aluminum surfaces primed with Concept 1K Etch Primer.
• Steel surfaces.
• Polyester spray filler.
• Glass reinforced polyester.
– MIXING RATIO:
• 4 parts Concept MS-100 2K Primer Surfacer by volume.
• 1 part Concept Uni-Hardener (MS) by volume. Fast is the recommended hardener.
• Up to 10% reduction with Concept 2K Thinner may be required.
– SPRAY GUN & PRESSURE:
• 2.0mm tip with a suction feed gun
• Pressure is 350 – 450 kPa. (The same condition applies for gravity feed)
– APPLICATION:
• Stir thoroughly before use.
• All surfaces must be thoroughly sanded and cleaned with Concept Wax & Grease Remover prior to application. Lightly rusted surfaces must be treated with Concept Light Rust & Metal Conditioner.
• Two to three, even coats are needed to obtain a 50 – 80 Micron Dry Film Thickness.
– SPRAYING VISCOSITY:
• 18 – 20 seconds B4 cup at 25°C.
– FLASH-OFF TIME:
• 5 minutes between coats at 25°C.
– DRYING:
• 3 – 4 hours at 25°C for a Dry Film Thickness of 50 – 80 Micron. • Low Bake for 30 – 40 minutes at 50°C.
– SANDING:
• Wet sand thoroughly with either P600 – P800 before applying finish coat.
Reviews
There are no reviews yet.