U-POL Easy 1 Body Filler and Hardener 3lt. Panel Beating, Nikki.
An easy to use, smooth textured polyester filler for deep repairs. The non-sag formula is ideal for use on vertical or horizontal repairs and its lightweight formula bonds to multiple substrates including galvanised steel, metal and GRP.
- Smooth textured, tack free finish
- Easy spreading and quick to shape
- Non-sagging when used on vertical surfaces
- Very smooth and easy to spread making easy application.
- Non-porous formula will not shrink.
- Quick drying time promoting efficiency.
Typical Use Ideal for filling and shaping medium to deep panel damage
Surface Preparation
Bare Steel S2001 Fast/S2002 Slow Solvent-Based Degreaser P80
Aluminium S2001 Fast/S2002 Slow Solvent-Based Degreaser P180
Galvanised S2001 Fast/S2002 Slow Solvent-Based Degreaser P180
Original Paint S2001 Fast/S2002 Slow Solvent-Based Degreaser P180
GRPS2000 Water-Based Degreaser P180
- EASY 1 LIGHTWEIGHT BODY FILLER FOR DEEP REPAIRS has superb adhesion to all the substrates above.
- For best results, good preparation is essential.
- Clean and degrease removing dirt, oil, grease and wax using cleaning solutions such as U-POL’s SYSTEM 20
- Degreasers.
- Abrade with grit paper as stated above for each respective substrate.
- Re-clean, dry and degrease the abraded substrate ready for application.
10 Degree Celsius
Mixing ratio (BPO Hardener): 3%
Gel Time: 6 – 7 minutes
Sandable after: 20 minutes
20 Degree Celsius
Mixing ratio (BPO Hardener): 2%
Gel Time:4 – 6 minutes
Sandable after: 15 – 20 minutes
30 Degree Celsius
Mixing ratio (BPO Hardener): 1%
Gel Time: 4 – 5 minutes
Sandable after: 15 minutes
Maximum Fill Depth 4 – 7 mm
Infrared Bake: 50 – 80 cm, 80 °C, 5 minutes
- Mix thoroughly on an Onion Board Mixing Palette.
- Follow mix ratio carefully. Do not under or over catalyse.
- Apply with a pressing action to reduce air entrapment.
- Not recommended for applications below 5°C
Sanding
Initial Sanding P80 – P120
Final Sanding P180 – P240
U-POL recommends using Guide Coat Aerosol during the sanding process to identify the high and low spots.
A U-POL Finishing Filler such as DOLPHIN GLAZE can be used to fill imperfections such as pin holes and scratches prior
to painting |
Reviews
There are no reviews yet.