Transtar TexCoat Chipguard White . Flexible protective Coating 4303

Tex Coat is a flexible protective coating. Texture can be varied to match OEM textures as found on rocker panels, valances, etc. 

Suitable Substrates
• Raw plastic – rigid (SMC, BMC) • Bare steel • 1K primer
• Raw plastic – flex (ABD, PPO) • Bare galvanized • 2K primer
• Raw plastic – soft (PUR) • Bare aluminum • Self etch primer
• Plastic part- primed • OEM E-coat • Body filler
• OEM finish & old paint work – non-reversible

• Tex Coat is a rapid drying, flexible protective coating.
• Texture can be varied to match OEM textures as found on rocker panels, valances, etc.
• Paintable in 30-45 minutes.
• Highly chip resistant.
• Convenient aerosol requires no equipment clean-up.

Surface Prep & Application

• Clean with wax and grease remover. 
• Remove existing finish and clean again with wax and grease remover.
• Prepare bare metal with appropriate Transtar metal primer.
• Sand with 220grit. 
• Remove sanding dust with Wax and grease. 
• Shake Tex Coat can vigorously. 
• Apply in 1 – 3 light even coats. 
• Film build should be about 3.0mils per coat. 
• Total film build should not exceed 8-10 mils. Flash 10-15
• minutes between coats. IMPORTANT: KEEP CAN IN MOTION WHEN APPLYING
• TO AVOID EXCESSIVE FILM BUILD. 
• Allow final Tex Coat application to flash 30-60 minutes at 75°F (25°C) before topcoating. Follow manufacturer’s instructions before topcoating.

Flash Times/Dry Times

Flash time …………………….10 – 15 min @ 70°F (21°C)